Bennett M120 Sport Hydraulic Trim Tab System 10x12in

#9006113
Warranty Badge - 5-Years
Hurry! 1 left in stock - Ready to Ship
Calculate Shipping
Australia Wide
includes any items in cart
Why pay $1,219.00
ONLY $1,179.00
SAVE $40.00!

Seen a lower price? Ask us to beat it

Add Items to Cart

Click on the image above to view full picture

Details

Details

Balance loads, plane faster, increase efficiency

Give your boat an extra kick! The Bennett M120 Sport Hydraulic Trim Tab System gets you up on plane quickly and correct listing at nearly any speed, regardless of weight distribution or sea conditions. The unique batwing design provides 30% more lift than conventional trim tabs. These benefits add up to less drag on the hull, reduced engine stress, increased speed and decreased fuel consumption. Ideal for trailer boats in the 17-to-23-foot range with limited transom space.

Getting and Staying Trimmed
Most boats "break over" (get on plane) at a particular speed. This speed is determined by weight distribution, water conditions, etc. Bennett Trim Tabs enable your boat to plane at speeds lower than natural planing speed. By pressing the control to the "Bow Down" position, your trim tabs move down. This will raise your stern and lower your bow, getting you up on plane faster, usually increasing your speed.

Bennett M120 Sport Hydraulic Trim Tab System Features:
  • Sport batwing tab design provides 30% more lift
  • Get on plane fast, and stay on plane at intermediate speeds
  • Correct listing and uneven loads
  • Improve visibility and safety
  • Improve fuel efficiency by 20-30%
  • Reduce pounding and eliminate porpoising
  • Low maintenance, long-term value, and ease of service
  • Exclusive transom mount interlocking tab design
  • Increase speed
  • Get you out of the "hole" and on plane faster
  • Smooth out a rough ride
  • Pull more/heavier skiers
  • Engine configuration: Single I/O or Single Outboard

Bennett M120 Sport Hydraulic Trim Tab System Specifications:
  • M120 Span x Chord: 25.4 x 30.48 cm (10" x 12")
  • Trim tabs: Stainless steel
  • Actuators: High impact fibreglass-filled nylon and flexible nylon (upper hinge)
  • Hydraulic Power Unit (HPU): approximately 18 amps (broken-in) and operates on 12 volts DC (except 24 volt HPUs)
  • Helm Control: Controls on 12 volt systems use 20 amp in-line fuse (24V systems use 10 amp in-line fuse)
  • Hydraulic Tubing: 1/4" (outside diameter)

What's in the Box:
  • 2x Stainless steel trim plane assemblies
  • 2x Hydraulic actuators (A1200SRC)
  • Hydraulic power unit (V351HPU1)
  • All necessary wiring, tubing and hardware
  • Installation video

Products You Recently Viewed

Recently Viewed